Hydroxeur Pedi – Jetunderwatermassage appliance ST-
Design Part-no. AT3410
With air and water in a single channel system, through that
is a vibration jet massage and a micro fine mixture of water
and bath essence possible.
Consisting of:
Tub self-supporting, compactly built, Sloping tub inside
with leg- and foot support for relaxed treatment. Material
Acrylic glass seamlessly vacuum deformed, cladding made
of polyester, with service doors for connections and inspection.
Water consumption appr. 60 Liter, All water carrying parts
made of plastic.
Tub fittings:
- 40
Special jets
- 5Jet
channels
- 1
Plastic suction shell with sieve
- 1 Plastic
drainage set 1 1/4"
- 1 Plastic
water jet pump for mixing in air
- 1 Special
plastic pump, water turn over approx. 200l/min. 230 V WS
50 Hz
- 1
Motor protection switch
- 1
Dry run protection
- 1
Tub filling battery mounted in tub rim
Consisting of:
- 1
1/2" Thermostat
- 1
Filling valve
- 1
Valve for air mixing
- 1
Filling shell according to DIN 1988
Control:
1 electronic control unit with: function ON - OFF and digital
remain time display
Technical data:
Dimensions:BxTxH 900 x 900 x 550/670 mm
El-connection 230 V, 50 Hz, 1,1 kW
Tub hygienic according to DIN VDE 0750 with Addison cleaning
agent (ZR0200) and Bayromed active oxygen tablets (ZR0100)
|
Hydroxeur Pedi - Jet under water massage appliance ST -
Design Part-no. AT3410
On-site connections
1. Cold-water sleeve ½" flush with floor
2.Warm-water sleeve ½" flush with floor
3. Electr. floor connection 230 V/1/N/SL 50 Hz, cable 1,5
mm², 1,1 kW, 7A
4.
Drainage with odour trap ??70, simultaneous for room drainage
On-site connections only with cleaning shower:
5. Cold-water sleeve ½" flush with floor
6. Under plaster valve ½" cold.
On-site safety measures
Stop
cock warm and cold water.
If
the drain of the tub is stationary connected, a room draining
must exist.
All-pole circuit breaker within the room. Ground fault circuit
indicator, nominal fault current max. 30 mA , Minimum door
width: 75 cm.
Weight: 70 Kg.
|
